Assessed First
Mold Removal & Remediation in Greensboro, NC
Containment, HEPA filtration, and antimicrobial treatment remove mold colonies at the source and stop cross-contamination through the rest of the home. Mold remediation removes affected porous materials and corrects the moisture source that allowed growth. The work is done under containment with HEPA filtration so spores are not carried into unaffected rooms, and the area is cleared only once the underlying moisture problem has been resolved.
Remediation is the step after the assessment, not before it. A local pro establishes how far the growth extends and what is feeding it, because removing what is visible while the moisture source is still running puts the same colony back in the same wall. Texas and several other states also set a square-footage point above which the work has to be done by a licensed remediator — the service note below covers where that line falls in this city.
Every pro in our network is licensed and insured in North Carolina.
Frequently asked questions
The soil is red and rolling. Shouldn't it drain?
Saprolite drains when it is open and then seals when a hot July bakes the surface. The next cell hits a crust, not a sponge. Water that should have soaked ten feet from the downspout instead runs the yard into the crawlspace vent on the low side.
Why July here when Durham's peak is September?
Different geology, different storm. This side of the Piedmont takes summer heat-driven cells; the Triassic basin a county east takes tropical remnants in September. A crawlspace here is wetted by short bursts all summer, which is a humidity problem as much as a flood problem.
The weepholes in the brick are stained orange. Is that the leak?
It is the clay leaving. Water moving down the cavity behind the veneer carries saprolite fines out the weepholes. The stain means the cavity is wet, not that the brick itself failed. Clearing the holes and finding why the cavity is taking water are the next steps.